Layer overhang

At what overhang angle the bead loses support from the layer below.

α1 mmThe last two layersawh

The darker part rests on the layer below, the lighter part hangs in the air; the dot is the bead centre.

020406080020406080100α (°)supported share (%)αlim
= 0.2 mm /2 = 0.1 mm
mm
°
mm
Step-out
0.2 mm
Supported share
56%
Limit angle above it the centre hangs
48.4°

What you can see here

  • For a wall to lean at from vertical, each layer steps out past the one below by ; at mm and 45° that is 0.2 mm.
  • Only of the bead rests on the layer below: about 56% at mm and 45°. From (here 48°) its centre hangs, hence the rule of 45° without supports.
  • A lower layer does not change the shape of the wall, because the step-out per millimetre of height is always . It splits it into finer steps and allows steeper overhangs.
  • The angle is measured from vertical, as in Cura; PrusaSlicer measures from horizontal (30° here is 60° there). It is pure geometry: spreading plastic and cooling shift the limit in practice.

Formulas

  • : step-out per layer (mm); : layer height (mm); : overhang angle from vertical
  • supported part of the bead; : extrusion width (mm)
  • the angle at which the bead centre stands over the edge of the layer below, that is