Gear train

A pair of gears trades slow turning and high torque for fast turning and low torque.

Input: rotorOutput: generator

Fewer than 17 teeth: a profile shift is needed.Motion slowed down 7.5 times, both gears equally.

010020030040050000.050.10.150.2n (rpm)T (N·m)
input 1.5 W output 1.2 W
rpm
Gear ratio
1 : 3
Generator speed
360 rpm
Input torque
119 mN·m
Output torque
31.8 mN·m

What you can see here

  • The gears roll without slipping on their pitch circles (dashed), in opposite directions, so the speed changes in the ratio of the tooth counts, : a 36-tooth gear turns a 12-tooth gear three times faster.
  • A gear train only passes power on: when the speed triples, the torque falls to a third and then by the factor (0.8 for plastic gears, about 0.98 for steel).
  • Fewer teeth give a faster output, but below 17 teeth (20° pressure angle) the cutter undercuts the tooth root and weakens it, so such a gear needs a profile shift.

Formulas

  • : output speed (rpm); : input speed (rpm); : teeth of the driving gear; : teeth of the driven gear
  • : gear ratio; below 1 the train speeds up
  • : torque on the input shaft (N·m); : input power (W), 1.5 W in the simulation; : angular speed (rad/s)
  • : torque on the output shaft (N·m); : efficiency of the gear train, 0.8 in the simulation; the output power is