Clearance or interference
A bearing slides into the hole freely or has to be pressed in, depending on the diameters.
The blue-violet band is clearance or interference; deviations are enlarged 40 times relative to the diameter.
- Fit
- Clearance
- Per side
- 0.03 mm
- Relative to diameter
- 2.73‰
What you can see here
- Only the difference in diameter counts, : positive is clearance, negative interference; a 22.06 mm hole and a 22.000 mm bearing give mm, or 0.03 mm of clearance per side.
- With interference the hole stretches and the bearing ring is squeezed; the stress depends on the relative difference , so 0.02 mm of interference squeezes a 6 mm bearing harder than a 60 mm one.
- 3D-printed holes come out 0.1 to 0.2 mm too small, since a circle becomes a polygon and plastic shrinks; print the seat first as a test piece with several diameters.
Formulas
- : difference in diameter (mm), positive is clearance, negative is interference; : hole diameter (mm); : bearing diameter (mm)
- : hole deviation (mm); : bearing deviation (mm), zero in the simulation; the nominal size cancels out
- clearance or interference per side (mm)
- relative difference in per mille; : nominal size, that is the bearing diameter (mm)