Extrusion flow

How much plastic the hotend must melt per second, and when print speed is too high.

vBead cross-sectionwh

The dashed rectangle is the section ; a real bead has rounded sides.Above the limit the hotend cannot keep up: the bead is thinner and has gaps.

050100150200250300010203040v (mm/s)Q (mm³/s)vmax
flow hotend limit
mm
mm
mm/s
Flow
8.14 mm³/s
Hotend load
54%
Filament speed
3.38 mm/s
Highest speed
184 mm/s

What you can see here

  • Flow is the cross-section of the bead times print speed, . At mm and mm the rectangle would overstate the cross-section by about 10%, because the bead has rounded sides.
  • A lower layer means a smaller cross-section, so the same flow allows faster printing: at mm a 0.1 mm layer allows almost twice the speed of a 0.2 mm one.
  • Past the limit the hotend extrudes less than the slicer asked for, so the bead is thinner and has gaps. The limit is fixed here (15 mm³/s); in practice it depends on the nozzle, material and temperature.

Formulas

  • : flow (mm³/s); : cross-section of the bead (mm²); : print speed (mm/s)
  • : extrusion width (mm); : layer height (mm); cross-section in the stadium model, for
  • : filament speed (mm/s); : filament diameter (mm), here 1.75